Standard Foundation with Legs Assembly:
Our Standard Foundation with Legs has an easy, tool-free design. Watch the video below or follow the instructions thereafter to assemble the product.
Step 1: Unbox
First, unbox your Avocadoo Foundation with Legs. In the box you'll find:
4 Frame Pieces
1 Support Beam
6 Legs with Attached Screws
4 Joint Pins
2 Sets of Slats
Step 2: Set Up the Foundation
Arrange frame pieces into a square, ensuring the bottom screw holes touch the floor. Gently slide interlocking joints together at each corner. Secure by inserting one joint pin into the pre-drilled holes in the joints.
Step 3: Attach the Legs
Using two people, flip the foundation over so it's upside down. Attach one leg by screwing it into the pre-drilled hole at one corner. Repeat for the remaining three corners.
Using two people, flip the foundation right side up. Grab the support beam. Attach one leg on the left side by screwing it into the pre-drilled hole. Repeat with the left side.
Step 4: Attach the Support Beam
Leg-side down, gently slide the notch at either end of the support beam into the corresponding notch in the center of the foundation base.
Step 5: Add Slats
Starting at the top of the foundation, gently unfold the first set of slats, ensuring the top and bottom slats are secured on the black strip on the top corners and middle of the foundation.
Start the second set of slats where the first set ends. There should be no gap where the two sets of slats meet. Gently unfold them toward the base of the foundation, securing them on the black strip on the edge of the foundation.
Step 6: Enjoy!
High-five and admire your handiwork!
Heavy Duty Foundation with Legs Assembly:
Our Heavy Duty Foundation with Legs has an easy, tool-free design. Watch the video below or follow the instructions thereafter to assemble the product.
Step 1: Unbox
First, unbox your Heavy Duty Foundation with Legs. In the box you'll find:
2 Side Rails
2 End Rails
2 Central Support Rails - (*Twin, TXL and Full will have 1 Central Support Rail)
4 Fast Lock Pins - (all 4 pins shipped installed in side/end rails)
2 Support Slat Packs - (7 slats per pack)
10 Plastic caps, 10 Legs (TW, TXL, FULL)
12 Plastic caps, 12 Legs (QN, CK, EK)
Step 2: Set Up the Foundation
Remove side pieces and end pieces from box. Un-wrap rubber band at
joint locations and remove Fast Lock Pins from the Fast Lock Blocks. Lay
all components separately on the floor similar to image A above.
Step 3: Align Fast Lock Blocks
Align Fast Lock blocks in each of the four corners.
Step 4: Insert Fast Lock Pins
Insert Fast Lock Pins into each of the Fast Lock Blocks, pushing firmly to
ensure proper alignment.
WARNING - When removing the Fast Lock Pins,
only PULL from the top. DO NOT PUSH the pins
from the bottom as they may pop out at a high velocity.
Step 5: Insert Legs
Insert leg into each of the Fast Lock Blocks located in the corners and
in the middle of the side rails, twisting firmly to ensure proper alignment.
Step 6: Connect Center Rails
Line up each of the Center Rails with the corresponding “Tapered
Slide Connector” and firmly push down into place, making sure they
face upward.
Step 7: Add Support Slats
Start one end of each Support Slat Pack against the head/foot board,
with the male Velcro facing down to firmly catch the female Velcro
contact point on each side rail. Unroll the Slat Packs towards the center
fully extending them.