Step 1, Unbox.

First, unbox your Green Mattress Foundation with Legs. In the box you'll find:

4 Frame Pieces

1 Support Beam

6 Legs with Attached Screws

4 Joint Pins

2 Sets of Slats

Step 2, Set Up the Foundation

Arrange frame pieces into a square, ensuring the bottom screw holes touch the floor. Gently slide interlocking joints together at each corner. Secure by inserting one joint pin into the pre-drilled holes in the joints.

Step 3, Attach the Legs

Using two people, flip the foundation over so it's upside down. Attach one leg by screwing it into the pre-drilled hole at one corner. Repeat for the remaining three corners.

Using two people, flip the foundation right side up. Grab the support beam. Attach one leg on the left side by screwing it into the pre-drilled hole. Repeat with the left side.

Step 4, Attach the Support Beam

Leg-side down, gently slide the notch at either end of the support beam into the corresponding notch in the center of the foundation base.

Step 5, Add Slats

Starting at the top of the foundation, gently unfold the first set of slats, ensuring the top and bottom slats are secured on the black strip on the top corners and middle of the foundation.

Start the second set of slats where the first set ends. There should be no gap where the two sets of slats meet. Gently unfold them toward the base of the foundation, securing them on the black strip on the edge of the foundation.

Step 6, Enjoy!

High-five and admire your handiwork!